Rear Diamond Series Stubby Bumper for Jeep TJ/YJ Wrangler

If you're looking for a bumper that's gonna tackle the toughest of trails than you need three things: strength, recovery points, and approach angle.

Our boxed in design provides a strength advantage over other similar bumpers on the market. The low pro design gives you superior approach angle while still protecting your frame, meaning less hanging up on rock, and with two 3/4" D-Ring mounts you're ready in case things get tricky. It also features a built in dimple died step plate and 2" receiver hitch for functional versatility. 

These rear cross member bumpers are the best combination of functionality and value.

FEATURES:

• Fits 1987-2006 Jeep YJ/TJ Wranglers
• 1/4 inch Steel Construction
• Laser Cut 3/4 inch D Ring Mounts
• High Approach Angle Design
• Integrated Hitch Receiver (See notes below)
• Hardware Included
• Comes Bare Steel 

Hitch Receiver Notes: Due to it's stubby design, clearance from center of hitch pin hole to back of bumper is ~1-3/4". Using a "normal hitch" will require cutting a square hole in factory crossmember for the hitch to slide back far enough to pin or using a hitch with a pin hole that is no longer than 1.75" from the end of the hitch tube. While this bumper/receiver is built extremely strong it has not been traditionally "rated" for towing, use at your own risk. 

Installation by professional mechanic is always recommended when performing modifications to your vehicle. Hitch not tested/rated for towing, use at your own risk. 

This item is not eligible for return in accordance with our return policy.